Use code SCNEWCUST15 for 15% off ALL scooters through month-end. Redeem here.
Fixing a Razor E300 Electric Scooter Tire: Step-by-Step Guide
To shop our replacement tires and learn more about the different types of tires for electric scooters, see here.
**We also have videos for replacing tires on youtube. **
If you're a Razor E300 electric scooter owner, then you're likely enjoying its top-tier performance on your daily commutes. However, like any other wheeled vehicle, scooter tires can sometimes run into issues, such as punctures or general wear. When that happens, it's essential to know how to fix a Razor E300 electric scooter tire, so you can get back on the road safely and efficiently. In this comprehensive guide, we'll walk you through the steps needed to repair or replace your Razor E300 scooter tire.
Gather the necessary tools: Before you begin, make sure you have the following tools on hand: a wrench, tire levers, a bicycle pump, and a patch kit or replacement tire.
Turn off and unplug the scooter: Make sure the scooter is powered off and disconnected from any power source to prevent any accidents while working on it.
Remove the wheel: For safety purposes, first remove the wheel from the scooter. For the rear wheel, use the wrench to remove the two nuts holding the wheel in place. Then, slide the wheel off the axle. For the front wheel, use the wrench to loosen the axle bolt, then carefully slide the wheel off as well.
Deflate the tire: Before you can repair or replace the tire, you'll need to release the air inside. Press down on the valve with a tire lever or your fingers to deflate the tire.
Remove the tire: Once the tire is deflated, carefully insert the tire levers between the rim and the tire. Use them to pry the tire off the rim by moving the levers around the edge of the rim.
Inspect the tire: Check for any punctures, tears, or general damage. If the tire is beyond repair, you'll need to replace it with a new one.
Repair or replace the tire: If the tire has a puncture, use your patch kit to seal the hole according to the kit's instructions. If the tire needs to be replaced, install the new tire onto the rim by stretching the tire beads over the circumference of the rim.
Inflate the tire: Using a bicycle pump, inflate the tire to the recommended PSI (usually around 40-45 PSI). Make sure not to overinflate the tire, as this can cause damage.
Reinstall the wheel: Once the tire is repaired or replaced and inflated, slide the wheel back onto the axle. Use the wrench to tighten the nuts or axle bolt securely.
- Test your scooter: Before taking your Razor E300 scooter out for a ride, test its performance by turning it on and checking its responsiveness. Make sure the wheel is spinning smoothly and the scooter is running properly.
Following these steps will ensure that your Razor E300 electric scooter tire is in top condition and ready for your next ride.

