How to Put the Chain Back on a Razor E200 Electric Scooter: A Step-by-Step Guide

If you own a Razor E200 electric scooter, you know that it's important to keep it in good working condition. One common issue that riders face is the chain coming off its track. Fear not - putting the chain back on your Razor E200 electric scooter is an easy task if you follow these simple steps:

1. Turn off the scooter: Before attempting to put the chain back on, ensure the scooter is turned off and the charger is disconnected to avoid any potential accidents.

   
   



2. Locate the chain tensioner: The chain tensioner is a small, silver, adjustable device located on the rear wheel of the scooter. It's essentially an S-shaped metal piece with a screw in the middle.

   
   



3. Loosen the tensioner: Using a wrench, loosen the nut on the tensioner screw. This will give you some slack and make it easier to put the chain back on.

   
   

1. Guide the chain back onto the sprockets: With the tensioner loosened, carefully guide the chain back onto the front and rear sprockets. Ensure that the chain is sitting securely on the sprockets and not hanging off any of the teeth.

   
   



2. Adjust the tensioner: Once the chain is back on the sprockets, use the wrench to adjust the tensioner screw until the chain has the proper amount of tension. The chain should be tight enough that it doesn’t fall off but not so tight that it prevents the scooter from moving freely.

   
   



3. Secure the tensioner: Once you have the chain tensioned correctly, secure the tensioner by tightening the nut on the screw.

   
   

1. Test the scooter: Turn the scooter on, and give it a quick test. Make sure the chain stays on during operation and does not make any unusual sounds.

That’s it! With these simple steps, you can have your Razor E200 electric scooter's chain back on and ready to ride in no time. Remember to maintain the chain tension by periodically checking and adjusting the tensioner as needed.