Use code SCNEWCUST15 for 15% off ALL scooters through month-end. Redeem here.
Step-by-Step Guide to Installing a Harness on Your Razor Pocket Mod Electric Scooter
Installing a new harness on your Razor Pocket Mod Electric Scooter is a crucial step to ensuring your rides are safe and enjoyable. Whether you're doing routine maintenance or replacing a worn-out harness, the following steps will guide you through the process with ease.
First, ensure that your Razor Pocket Mod is turned off and the charger is disconnected. Safety should always be your top priority when performing any maintenance on your electric scooter.
Begin by locating the battery compartment, which is typically found under the scooter's seat. Use a screwdriver to remove the screws or latches that secure the seat in place, then carefully lift the seat to access the battery compartment.
Once the compartment is open, you'll see the existing wiring harness which connects the battery to the scooter's motor and controls. Take note of how the harness is connected – a quick photo with your smartphone can help you remember the correct configuration later.
Proceed to disconnect the old harness. This may involve disconnecting terminals or unclipping connectors. If the connectors are tight or seem stuck, gently wiggle them back and forth while pulling to avoid damaging the terminal pins or the scooter's electrical components.
Now it's time to install the new harness. Start by placing the harness in the same position as the old one, aligning it with the connection points. If the new harness includes zip ties or any securing devices, be sure to have them on hand.
Connect the new harness to the corresponding parts of the battery, motor, and controls, following the configuration you previously noted or the photo you took. Ensure that each connector is fully seated and secure to avoid any loose connections that could cause malfunction.
Once all the connectors are in place, use zip ties if provided to neatly secure the wiring, avoiding any areas that move or generate heat when the scooter is in operation.
Before closing the battery compartment, double-check all connections to ensure they're firm and correctly installed. Once satisfied, replace the seat and securely fasten it back in place with the screws or latches you removed earlier.
Finally, turn on your Razor Pocket Mod Electric Scooter to test the new harness installation. If the scooter powers on and operates as expected, you've successfully installed the harness. If not, re-check your connections and ensure all connectors are properly seated.
Congratulations on installing a new harness on your Razor Pocket Mod Electric Scooter! Now you're ready to hit the road with confidence knowing that your scooter is in top condition.
Remember, proper maintenance is key to the longevity and safety of your electric scooter. If you encounter any difficulties or have concerns, don't hesitate to consult the Razor Pocket Mod manual or reach out to a professional technician.
![](https://static.wixstatic.com/media/855cc0_e23e880fee7f4beb90a4ce2b91b3ba5a~mv2.png/v1/fill/w_20,h_10,al_c,q_85,usm_2.00_1.00_0.00,enc_auto/Path%201_2x.png)
![](https://static.wixstatic.com/media/855cc0_e23e880fee7f4beb90a4ce2b91b3ba5a~mv2.png/v1/fill/w_20,h_10,al_c,q_85,usm_2.00_1.00_0.00,enc_auto/Path%201_2x.png)